State the difference between Three winding transformers and
Two winding transformers ? where its used?
- 8 Answers
- 38682 Views
- I also Faced
- E-Mail Answers
Answer Posted / agus
There is also another application of three windings
transformer with unloaded IV (Intermediate voltage) delta
winding. The function of this kind of IV delta winding is
for reducing unbalance in the supply side, when this
transformer is delivering power to an unbalance load.
| Is This Answer Correct ? | 24 Yes | 7 No |
Post New Answer View All Answers
Efficient electrical earthing in hard rock area
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
A d.c. Shunt motor is found suitable to drive fans because they require?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
Is there any guideline say about display of earthing value near to earth pit
How to Design green buildings services? What is the advantage to design green building?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
what is the difference between directional & non directional earth fault with example please explain.
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
how many Classification of fire extinguisher
what is basic difference betmeen normal & flame proof motor??
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
