difference b/w bus bar and tie line?if possible explain
with eg:
- 2 Answers
- 7688 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.aruna devi
No of feeder connected in a single line is known as
bus.Couple of two bus is called tie line.
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
Difference between RCCB, RCBO and ELMCB.
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
What are the advantages of a three-phase system over a single-phase system?
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
what is the voltage rating of chiller unit sensors
What is dielectric loss?
Make a list observation on Transformer?
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
before synchronizing an alternator,power factor is leading ,why?
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
what is the transformer turn ratio formula and give some examples?
