what happen for input voltage output voltage input current
output current and kva if we increase primery winding in
transformer?
- 1 Answers
- 3503 Views
- I also Faced
- E-Mail Answers
Answer Posted / prembujju
Load current increases and
causede iron loss which produces
over heat to failure the insulation
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
different aspects of voltage stability
Why we find the sensitivity for the CT's to check?
What is negative sequence over voltage element?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
List advantges of active filter over passive filter?
Discribe type of fault in DOL and stardelta startor.
Why is ignitor used in sodium vapour lamp
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What is center gravity load in substation?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
What are the main advantages of bode plot?
What is resistance reading of earth copper rod with grid and without grid?
What is the complete procedure of erection of electrical panel in industry
