can induction motor run over the rated speed ?
- 12 Answers
- 14944 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / padmanabh thakur
rated speed means no load speed .at no load, speed of rotor
is approximately equal to the speed of stator magnenetic
field,so slip become zero and hence torque devlop to rotate
rotor is also equal to zero.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What was the Dg set radiator and lube oil temperatures trip in ACB
How much dc volt applied in cathodic protection system?
how does commutator convert a.c to d.c?
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
what is differentila pilot supervision in the incomer control panel in the power station?
what is the difference between RMS & TRUE RMS VOLTAGE
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
how to calculation increase capacitor,increase power factor for three phase.
please send me privious exam's queation papers of section engineer(electrical).
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
How two nos. 130 kw D.C motor get synchronise using D.C drive.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
I want to merge a cable..in between two metering Cubicals which contains CT's and PT's and Energy meter..before taking merger..what are the common things required?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
