Do you know how to joint the H.T and L.T Cables?
- 23 Answers
- 57347 Views
- KESC, MGVCL, Nokia, Oil Country Tubular, Power Control, SAGT, Siemens, Simco, Vivek Engineers, I also Faced
- E-Mail Answers
Answer Posted / rvg.msceb
heat shrink joint is the best method. please check with
Rechem website.
No there is a new tehnology update that is Cold shrink
joint.
| Is This Answer Correct ? | 37 Yes | 7 No |
Post New Answer View All Answers
how to select fuse rating for a 3-phase motor ???
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
please send me privious exam's queation papers of section engineer(electrical).
There is any especial requirement for motor to drive through with VFD?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What is servo motor and what are different types of servo motor
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
I need HT sphere gap calibration table. Can any body help me.
Mention the methods for starting an induction motor?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
how to calculate insulation level of transformer?
