Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rvg
For calculating cable size,for a specific load current,
following facts to be considered:
1.Maximum load current.
2.under ground or overhead laying
3.max. temperature withstanding capability of cable insulation.
4.max. voltage stress withstanding capability of cable
insulation.
5. distance of load from the power supply
6. AC/DC supply and frequency .
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Transmission through a short line depends on
how to compute kAIC? with formulas...
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What is the formuala to calculate the rating of motor protection circuit breaker
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
What is accuracy of a measurement?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
How many types of faults are there in 3 phase power system?
How many types of colling system it trformers?
Please brief working principle & construction of permanent magnet AC Servo motor
what are the difference between PLC and embedded
How to calulate Locked rotor amper(LRA) for compressor type motors?
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
