Answer Posted / n arunkumar
CT secondary is 5A in Low voltage systems because we need
more graduation in measurement of current.Moreover measuring
range is small in LT system. but in High voltage system, the
measuring range is more.we need more accuracy. so we prefer
1A secondary in HT system.
| Is This Answer Correct ? | 24 Yes | 2 No |
Post New Answer View All Answers
I want to do a mini project. Now I'm studying in 6th semis tor EEE Engineering.
how many electricity poles are there and what are the names and their sizes.
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
what is load vs Torque curve & why it is used?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
What do you mean by distribution transformers?
Define closed loop control system.
What is the working principle of MIG welding? and its out put Voltage?
what is meant by directional earth fault and non directional earth fault? describe both.
why should the primary of transformer be connected in delta in a heat run test?
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
what is Different between Bilinear and Unilenier?
What is the reason that the humming sound is coming from the induction furnace panel?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
