Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / xxxx
it is the ratio of KVA to KW. In other words, it is the
cosine of the angle between voltage and current in an A.C
electrical circuit.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
What is the difference between acs 550 & acs 850
how cables go in and come out for distribution from the feeder pillar box?
What is knee point voltage of transformer?
how can i improve the power factor in domestic (230v)
Differentiate between magnetic field and magnetic flux?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What is a DC series motor?
Is electro plating what type of load whether resistive, inductive or capacitive loads
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
what is the Pickup/drop off ratio in BCPU relays
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What is pd controller?
