Answer Posted / uzy
whenever current flows through a wire there are i2rt losses
which r dissipated through resistors in the form of heat
also transformer has no moving part so all the
losses(unusable energy) in copper winding are evolving
through wires.
moreover the construction of transformer is closed type so
the heating becomes more.
since the oil tank is linked to the windings , as the
windings
heatup the oil filled in tank get heated and expands.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
what is the reactive power what is the use of it in system
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What is depreciation factor?
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
What is meant by celling voltage & current in excitor ?
Draw the line diagram of diffretial relay connected to transformer?
where the lexical paramater will use in fron end?
how will we calculate the copper wire load..
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
What is stacking factor? What is its approximate value?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why we use circular(Stepped) cross section in transformer core?
why the projects getting loss?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
