Answer Posted / tarun aggarwal
the power which is gernated in a station has high potential
and are transmitted by power cable like aac acsr etc which
have large diameter or high no.of strands. while control
cables are used in stations to control various activities of
equipments in stations like colling fan scontrols panel etc
in hydro plants also they are more flexible
| Is This Answer Correct ? | 13 Yes | 8 No |
Post New Answer View All Answers
What is meant by Load Encroachment in OHL Feeder Protection?
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
Define transfer function?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
what is the difference between skin effect
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
what is the question paper model for section engineer in RRB
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
howmany electrician should maintain for a 1000 kva used plant... in kerala..
why US countries maintains 110v and 60HZ
