For a centrifugal pump if the pump is running and we close
the discharge valve what is the effect
- 11 Answers
- 48928 Views
- Asian Paints, NFTDC, Reliance, I also Faced
- E-Mail Answers
Answer Posted / bharadwaj
By closing the valve there will not be that much effect on
the centrifugal pump .it keeps running
| Is This Answer Correct ? | 34 Yes | 44 No |
Post New Answer View All Answers
What are the problems that are associated with the expansion joints?
Name some common problems associated with dilute phase pneumatic conveying?
Is there any way to remove residual product left in pipes after a batch operation?
pls send me model paper of NPCIL for executive trainee. and syllabus of executive trainee 2015.
Explain what information is needed to specify a mixer?
What is the basic difference between dispersion & distribution in any polymer blend or alloy??
Define pcbs?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
What is gibbs free energy?
Explain the functioning of a three-way catalytic converter.
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
Explain what are the design considerations for a piping system for the transfer of slurries?
When specifying a cooling tower, should I look up historic wet bulb temperatures for my area or should I take measurements?
What are the customization steps in sap?
Are there any alternatives to scraping a shell and tube if a capacity increase will make the pressure drop across the exchanger too large?
