what is the meaning and full form of AYFY CABLE?
Answer Posted / har
A -ALLUMINIUM
Y - INNER SHEATH
F - FLAT ARMOURED
Y - OUTER SHEATH
Is This Answer Correct ? | 64 Yes | 11 No |
Post New Answer View All Answers
xfhnchncv?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
nwhat are the main Components of servo motor?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What are the two basic types of transformers?
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
What is stepper motor. What is its uses?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
we specify current in case of feeder but in case of distributor voltage, why?
How to perform a DC resistance test In Alternator and their proceduces?
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
Explain the method to keep noises low in a control system?