In orifice why the pressure and temperature are decreases?
- 14 Answers
- 13440 Views
- I also Faced
- E-Mail Answers
Answer Posted / phani
hi ramesh
i know pressure and temperature are reduces
but why what is reason behind that.
i want theoritical explonation
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What do you know about DG ,A,B,C, D, Check and safety of generator.?
i am studying mechanical engineering third year.. i want to study ine year marine bridge coure.. is that good for me?
what is the three types of combustion-control system?
Dear sir, I have applied section engineer post at rrb Chennai.Please send me the previous technical question papers and answers
Hello i want to design a portable 1/4HP pressure washer pump like elgi reciprocating pump which are being used in service station.what are the design aspects to taken in to consideration for making new pump.
hi every one, i want to make a coal grinder to mil 3 or 4 tons of coal dust per hour . if you guys help me with photos or some tecnical drawings that would be very kind of you.
What is a slined joint?
Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in
Find the greatest and smallest number among the given 5 numbers without using ‘>’ or ‘<’ operators
What are SAE ratings?
What is wet corrosion and galvanic corrosion?
What are the causes of boiler backfire and steps in how to prevent it from happening?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
HOW TO CALCULATE THE FILTER ELEMENT AREA FOR VISCOUS FLUIDS IN CASE OF PLAETED METTALIC FILTERS
Fabrication Defects
