what is the voltage between the earth & neutral
2 is there any continuity TO BE between earth & NEUTRAL
- 3 Answers
- 9509 Views
- Suzuki, I also Faced
- E-Mail Answers
Answer Posted / kumar
therotically it should be 0V. But practically differences
lies for which upper limitis are been mentioned.
For electronic systems like telecommunication it less than
5 V, for power systems less than 100V.
Secondaly , it may connected to earth depends on what
neutral you system needs i.e. fixed or floating.
Moslty it is connected to earth for safety of personal &
euipment.
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
how much cable size required for 70 kilowatt load.
which connection is safer series or parallel?usually which connection we prefer at home?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
what is PDU in transformer?? which company manufacture??
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Power Factor Correction Panel (Manual & Automatic)
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
How to checked frequency drive output voltages?
A jet of fluid strikes a plate What was the force required to counter it?
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
please send me privious exam's queation papers of section engineer(electrical).
what is the minimum winding resistance of 30hp compressor, to run or to switch on
