ARE YOU NOURVAS ?

Answer Posted / kiranbabu

Wats ur question?

Is This Answer Correct ?    4 Yes 4 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

why should small green grass ans small plant should not be there inside the transformer Yard in the factories

1210


How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke

1625


what are the things that can cause a three phase motor to crawl?

2879


can we install HT panel & LT panel side by side or how much clearance is required ?

1097


how could we know the size of cable by physical view?

1222






what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer

1524


why is the power generator connected as star earthed or star earthed through reactance and what its features ?

1178


I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok

1188


current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer

1161


A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03

1599


How to decide CT & PT ratings for a given transmission line carrying some rated voltage?

1890


explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.

701


detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron

2621


Which standard we are following earthing resistance test

980


what is the AC Plant and how can do the work with parts and picture tell us 150 Tr

1558