what are active and Passive Components?
- 102 Answers
- 197625 Views
- AIT, Ariba, Baldwin, Birla, DELL, Electronics, Infosys, KarMic, L&T, Nokia, I also Faced
- E-Mail Answers
Answer Posted / shirish tandel
The main components used in electronics are of two general
types: passive (e.g. resistors and capacitors) and active
(e.g. transistors and integrated circuits). The main
difference between active and passive components is that
active ones require to be powered in some way to make them
work. Active components can also be used to amplify signals.
| Is This Answer Correct ? | 131 Yes | 45 No |
Post New Answer View All Answers
Tell me something about IN call Flow and what is the difference between the flows in both GSM and CDMA technologies?
Define what do you understand by reverse saturation current of a diode?
1.Explain 3D radar. 2.Method of mobile signal jamming. 3.Frequency hopping spread spectrum. 4.How does op-amp works in common mode? 5.Which flip flop is known as universal flip flop and why?
write a program to set all flags in 8085?
how does modulation reduce bandwidth
The effect of reheating is
which taype question pattern in hr round in telecom feild.
What is meant by saying at what current is transistor biased?
As a water tank loses heat, the temperature drops by 2 K/min when a heater is on, the system gains temperature at 4 K/min. A two-position controller has a 0.5 min control lag and a neutral zone of ± 4% of the setpoint about a setpoint of 323 K. Plot the heater temperature versus time. Find the oscillation period
write a c programme for add of two numbers with out use of arthematic operators
what are the best institutes in hyd for groups
What are the differences between microprocessor and micro controller?
HAI HELLO EVERYBODY, GOOD EVINING. THIS IS ANIL KUMAR. IAM WORKING AS A OSS-SR.ENGG IAM LOOKING FOR LEARNING TELECOM PROTOCOLS. PLZ HELP ME. HOW COULD I GET INFORMATION AND MATERILS.
Amplitude modulation is basically a A Summing of two signals B Multiplication of two signals C Subtraction of two signals D Non-linear process
What is the difference between plc and dcs control system?
