how would you come to know if a transformer is double wound
or auto? note that there is no tag. you are given only a
multimeter.
- 5 Answers
- 16014 Views
- I also Faced
- E-Mail Answers
Answer Posted / kishore
EXACTLY AS IN CASE OF AUTOTRANSFORMER SOME PART OF THE
PRIMARY WINDING IS MADE AS SECONDARY WINDING ...THERE IS NO
ELECTRICAL ISOLATION AS IN CASE OF TWO WINDING HERE
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What do you mean by screen of power cables?
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
im electrical engineer, could any one help me for FEWA exam questions please ?
What is the difference between relays and contactor construction wise?
how to calculate mf when meter and cTPT detail are given
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is the bundle conductor?
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
what is meant by carrier aided trip protection in transmission line
how much GROUND & NEUTRAL VOLT maintain in data center.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
What is quadrantal symmetry?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
How work of capacitor in dc supply...???
what is the difference b/w pvc cu conductor and cu breaded wire..?
