Answer Posted / rajesh tokalapudi
The main purpose of core in a tranformer is to provide a
low reluctance path between primary and secondary.
| Is This Answer Correct ? | 92 Yes | 8 No |
Post New Answer View All Answers
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
Is MEN and RCD related to each other ?? IF yes then how??
What are the different power system losses and how can it be eliminated?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
what is a vector protection in transformer
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
what is the acceptable limit value for Desolve Gas Analysis/
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
explain single phase series motor
what is Fan Control Cubicle
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
