WHAT IS NORMAL VECTOR GROUP USED FOR DESIGNING OF TRANSFORMERS??
- 11 Answers
- 20585 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivendu
Ynd1 and Dny1 and Ynz1 is the normal vector group used for
transformer construction.
| Is This Answer Correct ? | 12 Yes | 11 No |
Post New Answer View All Answers
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
11 kV line deraction check by an Engineer.
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
how can tell us the AC indoor or outdoor which Tr and formulls
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
ROC converges if poles and zeros lie inside a. Origion b. Z=1
why you don not show protection and type of isolation in key single line diagram?
How npn and pnp transistor works
how to wiring it with contactor and timer together
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
what is difference between earthingpits,earthing grid & earthing mess?
