Interested to Buy Any Domain ? << Click Here >> for more details...
Can any body help me,The GE Mark V control system is
windows based or Dos based?
- 3 Answers
- 7332 Views
- I also Faced
- E-Mail Answers
Answer Posted / prasannashankar
GE mark v control system is dos based system.
| Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is instrumentation instrumentation engineering?
What is zero elevation and zero suppression?
Why is the orifice tab provided?
selection criteria of control valve? and selection criteria of actuator explain in brief?
how to commission furnace ( water heater)
State bernoulli’s application.
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
what is The specifications for oriface instalation
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
what is the procedure of belt scale calibration?
how to calibrate Necleuonic level transmitter.?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
