How can you convert an SR Flip-flop to a JK Flip-flop?
Answer Posted / sukhiray
connecting the outputs to the respective inputs
Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
why we are not using the turbine flow meter in the steam service?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
Full form of KKS when use DCS.
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
How we connect a instrument with ground, Give brief explanation with help of diagram?
steps for installing orifice plate?
why fuse block is not used for AI signal?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
what diffrence b/w plc s7200,300,400
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection