identify the components of the tube light and explain how
they function???wat is inside the fluroscent tube???how it
works???
- 7 Answers
- 48612 Views
- NTPC, TPL, I also Faced
- E-Mail Answers
Answer Posted / abid ali khattak
Fluroscent consit on: Element, Fluroscent powder and gas.
Working Principle: When we apply the voltage to the
furoscent tube through starter. its creat a suffeciant
current and the gas which inside the tube make short the
element, which located both end of tube light.
| Is This Answer Correct ? | 32 Yes | 37 No |
Post New Answer View All Answers
why does make gain margin and phase margin on same plot.?
How they LT panel busbar size choose
what are the protecyion of transformer & generators
What is the purpose of stablization resistor in high impedance bus bar protection
Define load factor?
when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)
What is the difference between resistance grounding system and resistance earthing system?
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
how to calculate slip ring induction motor stator and rotor currents??
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
What is mean by STUB protection?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
What is systematic error?
