can any one tell me the formula for calculating the power
and unit consumpetion
- 9 Answers
- 13982 Views
- Avalon, I also Faced
- E-Mail Answers
Answer Posted / vinothbabu.k
P=(1.732*VOLTAGE*AMPS)/1000,
FOR UNIT CONSUPTION:
KWATTS*HOURS=UNIT-ITS FOR INDUCTIVE LOAD,
FOR RESISTIVE LOAD THE ABOVE IS CORRECT,LAMP HEATER IS
RESISTIVE LOAD,
IT DEPANDS ON TYPE OF LOAD.
AND FOR CAPACITIVE & INDUCTIVE LOAD NO OF WORKING HOURS
WILL BE VARRY,FOR EXAMPLE TAKE FRIDGE WAS WORKING FOR 2
HOUR IT TAKE 750W MEANS WE SHOULD NOT
CALCULATE .750*2=1.5KWHR/UNIT,FRIDGE IS A CAPACITIVE LOAD
IT WILL ON OPPROXIMATELY 35 MIN FOR EVERY PER HOUR SO WE
SHOULT TAKE FOR 2 HRS IT WILL ON 1.05HRS FOR 2 HRS,
SO 750*1.05=0.787 UNIT
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
can i use 2000/5A Clamp meter to measure HT cable
in dc shunt motor if field winding is shorted then
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
How do I calculate/select Droop CT ratio for various capacity of generators?
what is through fault?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
Why we cant store an ac power. If we coo store in which device we can?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What is the technical difference between On delay timer and a Star delta timer?
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
