in india,we use 230V,50 Hz,whereas many other countries use
110V,60Hz.what r d advs and disadvantages of each of them?
Answer Posted / sayan
Nothing can be specified about the advantages & the
disadvantages of 230 V & the 110 V supplies.
It is the rating of the equipments that decides the voltage
level. In a simlar fashion, we can have control circuits
working at 230V (A.C. / D.C.), 110V (A.C. / D.C.).
Is This Answer Correct ? | 9 Yes | 38 No |
Post New Answer View All Answers
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
how does the thyistor work in dc drive?
what are the disadvantages in GIS over AIS
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
what is the control circuit for operating the clean room air shower
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
What is the ratio of Booster transformer?
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
On what basis the the size of Lightning arrester for buildings are selected ?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is meant by re-rolling motor? how it differs from standard motor?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value