Interested to Buy Any Domain ? << Click Here >> for more details...
what is inrush current in transformer?
- 17 Answers
- 43312 Views
- Bhel, Essar, GMR, I also Faced
- E-Mail Answers
Answer Posted / amit mewada
Inrush Current will be generate only during switching on
the transformer.
When we switching on the transformer, its flux is also
start increases with increases in voltage. Normally flux
will be 90 degree lags behind voltage but during starting
condition like first half cycle (this will also continue
for other few cycles) flux peak will increases approx two
times than its normal value. Similarly current is also
increases approx two times from its normal peak value. This
will be more dangerous when any residual flux is available
in transformer.
Inrush current has normally two parts. First is DC
component & other is 2nd Harmonics.
| Is This Answer Correct ? | 24 Yes | 7 No |
Post New Answer View All Answers
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
Explain the method to keep noises low in a control system?
how to calculate the tarriff for an industry whose kva demand is 10 mva
how to decide the panel size like MDB ,SMDB PANEL SIZES
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
What is the role of feedback in a closed loop control system?
what is stper motor
What's the difference between non break power supply and non break non short break power supply
Vaccum circuit breaker
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Do you know what is dry-out test in x'mer
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
how much flux density of CRNO core
