what is purpose of using reactor in substations.
Answer Posted / minal
in order to balance the capacitance current that is
produces in substations, we are using reactor.
we know that xL =i/xc.
Is This Answer Correct ? | 38 Yes | 16 No |
Post New Answer View All Answers
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
why and how voltage sharing in transformer, during magnetic balance test ?
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
What is the capacitance values of 132,220,400 & 765 kV current transformer
What do you mean by turns ratio of instrument transformer?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
which type of stability limit is higher,steady state or transient? why?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what are the application of over current relay?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Explain about p.t?
role of europe union in UK safety legistlation (electrical safety)
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....