how u calibrate pneumatic n motorized c/v?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
I married here in the Philippines to american citizen,we have one child and it's a boy and he was born last January 18,2010,so now i'm planning to apply my visa just to see him.what kind of visa should i supposed to apply with my son?PLease i need your answer as much as possible.thank you
hi frndz. dis is pravin m going to atend visa interview my problem is here i hope you all sugest me. i did mba in india. now am gong to again pursuing mba.if vo vil ask why do you choose again mba what should i reply.
how a t code works
sir iam from khammam i completed my b.tec ECE from JNTU college of engineering pulivendula . And now i want to take groups coaching in HYDERABAD. can u suggest me one good coaching centre for me, and i want to stay in hostel so i should hav ostel facility nearby
what is charger supervision and control supervision?
Hi SAP friens, i am a beginner in SAP-FICO and started giving interviews...i am struggling and lost couple of interviews because I couldnot tell any tickets/issues...can you help me by sending some tickets/issues to my mail id - rajendranmba@gmail.com...it would be of great help to me to clear the interview...please help.
what is differentila pilot supervision in the incomer control panel in the power station?
what does 80hz refresh rate indicates?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
do we have tds in nigeria
reduce the number of key strokes to execute this command : t char -t -v -f/dev/fd0
Calibration procedure for water rotameters
if i have done a research,and finally it has to be approved by my boss,but at the last moment i have found some major mistake inside it ,and if i disclose about it ,then my whole carrier will spoil,then how would i handle this situation?