1. Why a DC motor starter is called 3 point starter
Answer Posted / ravi693
Beacuse this 3 point starter has three points to save the
motor.
1) over load protection
2) no volt protection
3) starting huge currect protection
Is This Answer Correct ? | 242 Yes | 113 No |
Post New Answer View All Answers
electrical
What is a difference between indoor transformer and outdoor transformer of same rating
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
Post possible questions for Power Factor Panel FAT / SAT
what are the applications of PLC?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
how much excitation voltage required to generate 1mw power?
What is the difference between the impedance percent and impedance voltage ?
Explain the term parallel path in dc machin ?
Draw a SLD for main panel for school having connected load of 1200kw and emergency generator 200kw.also show the increase of additional load of chiller 225kw in the lv panel indicating meter postion size of transformer ,cables and capacitor bank.
why we used ZNO in Lightning arrester.
what are the application of over current relay?