Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

What is C.T, why it is used and what care should be taken
for that while connecting?

Answer Posted / sanjeevi

C.T STANDS FOR CURRENT TRANSFORMER USED FOR MEASURING
PURPOSE FROM LOW VALUE TO HIGH VALUE.
WHILE CONNECTING THE C.T SECONDARY WINDING OF THE C.T
SHOULD NOT KEPT OPEN COZ IF SEC OPENS IT WILL DEVELOP HIGH
VOLTAGE.SO HIGH CARE TO BE TAKEN.

Is This Answer Correct ?    1 Yes 3 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

how to calculate the capacitor to maintain power factor?

1259


What are the various kind of cables used for transmission?

264


What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?

1748


Is a d.c.compound motor is use as a booster? how?

1229


what is the difference between neutral and earth

1182






Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.

1180


What is the role of power pack in substation protection system?

1783


Why earthing is necessary for any equipment?

743


why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.

1149


differnce between single acting and double acting solenoid valves

1004


how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.

1222


if voltage bt phase & nutral is 38v in a panel board . whats the root cause.

1338


why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?

1161


Why High voltage are generate noise ?

523


how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating

1369