How power cable & control cable can be differentiate from
each other ?explain?
- 14 Answers
- 22604 Views
- Aster, Finolex, TCE, I also Faced
- E-Mail Answers
Answer Posted / minal
power cable is used to carry high voltage ac currents
whereascontrol cables are used to carry small dc voltages.
Power cables can carry noise also but control cables are
twisted and doesnot carry noise.
| Is This Answer Correct ? | 11 Yes | 15 No |
Post New Answer View All Answers
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
why swityard is necessrry requirement in any bis power distributin systems?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
How to know the Max. current caring capacity of the cable by its size ?
what are the different kind of cables used for transmissions?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
what is meant by IGBT how they differ from tyristor ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
any earth foult trip the relay but in welding time not trip by earth foult
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
what is mean by dual digital protection in the relay field?
what is proper capacitor placement? How to evaluate capacitor size?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
