Interested to Buy Any Domain ? << Click Here >> for more details...
How power cable & control cable can be differentiate from
each other ?explain?
- 14 Answers
- 26712 Views
- Aster, Finolex, TCE, I also Faced
- E-Mail Answers
Answer Posted / ravi_myla
control cable consists of a sleve of aluminium strandards
which will protect the signal through the conductor from
external noise and magnetic disturbance.
the same is not there in the power cable.
| Is This Answer Correct ? | 6 Yes | 21 No |
Post New Answer View All Answers
how to modify DOL control panel into Delta Y connection?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
why the check zone and main zone are used for Busbar Protn. scheem?
What is meant by harmonic distortion?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
Which types of gate insttaled in static switch. Please give me answer.
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
Why different Pressure switch used in marine boiler water circulation system
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
