Interested to Buy Any Domain ? << Click Here >> for more details...
how to control the generator output voltage?
what r the condition should satisfy for synchronization?
- 7 Answers
- 26800 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / pradeep kumar rawat
by contoling the fuel we can contol the output voltage of
generator.
condition for syncronization.
1-phase sequence shuld be same.
2-frequency shuld be same.
3- terminal voltage shuld be same
| Is This Answer Correct ? | 3 Yes | 24 No |
Post New Answer View All Answers
Why are iron cores in transformers made laminated?
Explain forward resistance, static resistance and dynamic resistance of a pn junction diode.
What conditions are required for transformer to operate at low frequencies ?
what is alluminium arm in ab conductors
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
Is electro plating what type of load whether resistive, inductive or capacitive loads
what is the safety points of vaccum circuit breaker.
how mass curve differs from hydrograph.
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
Why Stabilising Resistor used in REF circuit ?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
if field breaker of generator is closed prior to its rated speed on a power generating unit. what will be the effect on generator, unit transformer and starting transformer.
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
