How do you get help on a command after you have received the
% incomplete command response from a switch CLI?
A. type "history" to review the prompt before the error
B. enter a question mark to display all the console commands
C. type help followed by the command to see command parameters
D. reenter the command followed by a question mark to view
keywords
Answer Posted / guest
Answer: D
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is osi?
Explain the terms unicast, multicast, broadcast and multicast.
Name the 2 protocols are in wan technology?
Can yo define LNS
What are the different memories that are used in a cisco router?
What do you understand by redundancy?
What is formula of hold down time of eigrp protocol?
What is the frame relay, in which layer it comes?
Which type of transmission bus topology support?
What is a vlan? What does vlan provide?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What does the meaning of interface 0/0?
What are the protocols that are used by every layer of ip/tcp model?
What is half duplex and full duplex?
Define load balancing?