Interested to Buy Any Domain ? << Click Here >> for more details...
Which two steps are part of the process of creating Frame
Relay subinterfaces on a point to point connection? (Choose
two)
A. configure the router to forward all broadcast packets
B. remove any network address assigned to the physical interface
C. configure the local data link connection identifier
(DICI) for the subinterfaces
D. cartoon the total committed information rate (CIP)
available among the subinterfaces
- 1 Answers
- 3922 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B, C
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the difference between ‘bit rate’ and ‘baud rate’?
Differentiate between broadcast domain and collision domain
Which command we give for live view of remote site routers?
What are the ranges for the private ips?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
What is the difference between full duplex and half duplex?
What is the working of router?
What is the difference between rip and igrp?
What is the function of the Application Layer in networking?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
Explain protocol?
What is a vlan?
What are the three sources of signal degradation on a data link?
What is icmp protocol?
Explain the difference between igp and eigrp?
