Answer Posted / krishnakumarnair
8 Run levels
init 0 -ok prompt(open boot prompt)
init 1- single user with system administrator mode.
init 2 -multi-user mode.
init 3 - Extend multi-user mode
init 4 -Is available to be defined as an alternative
multi user environment configuration. It is not necessary
for system operation and is usually not used.
init 5 - Shut the machine down so that it is safe to remove
the power.Have the machine remove power, if possible.
init 6 - Stop the operating system and reboot to the
state defined by the initdefault entry in /etc/inittab.
| Is This Answer Correct ? | 16 Yes | 25 No |
Post New Answer View All Answers
If the root disk is failed how can change it?
There are two nic cards on a sun server. I need to connect one nic to pupic ip and another nic to DMZ. Could you tell me how to configure step by step?
How to make SUN server as router in subnetwork?
Which command is used to backup and restore solaris file system?
How to create core dump and crash dump #coreadm .
How can u find a file which is logged in last week?
After first installation of Solaris 10, what and all the Securities We need to set and how ?
How to configure email notification in solaris 8? We are using netbackup 5
What are the differences between the command line and graphical user interface?
How to add a new LUN in exit disksets (metasets) in solaris please answer me step by step procedure?
Write the steps involved in creating and executing a program to implement the “case” command.
Where do you get Alarm prompt?
What does pkgadd command do?
please post step by step installation of packages from the EIS cd..
what are the alarms in solaris?
