How do we check transformer losses and what are the ways to
minimise it.
Answer Posted / sumitgarg
we can check a trans losses by open circuit and short
sircuit test.
to minimise these losses we shuold have a good cooling
system. apart from that all other points are related with
the insulation of the core,permitivity etc.
| Is This Answer Correct ? | 27 Yes | 10 No |
Post New Answer View All Answers
What happened when capacitor connect series in ac circuit?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
What are the advantages of speed control using thyristor?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
if sf6 gas low in gis what will happen
What are the types of piano switches?
what is the current setting for different relay protection for transformer .