Interested to Buy Any Domain ? << Click Here >> for more details...
what is runout? how it is measure? which is the refrence?
- 14 Answers
- 98646 Views
- Greaves, Magna Infotech, I also Faced
- E-Mail Answers
Answer Posted / phani
runout means the radial play of the rotor or shaft.
it must be in between 0.02 to 0.03 for large turbine rotors.
measuring method:
First of all u have to conform how many areas u want to
take run out. On that basis u put the dial guages on that
flanges or bearing journals.
setting of dial guage is in such a way that it must be sit
on the parting plane and the dial point must be touch that
corresponding flange or bearing journal.
press the dial upto 5mm pressure. and set the dial into
zero and that is the reference point i.e. zero point
rotate the rotor and take the readings for every 90 degrees
of rotation.
At zero degree what is the reading, not down
at 90 degree reading, 180 deg reading, 270 deg reading and
finally again 0 degree reading.
Out of these check where is the max reading u observed.
Whether the max reading is within the limit or not u check
thatone.
This total process i am telling is regarding turbine rotor
run-out only.
But whatever it may be the process is same but the limits
may change.
| Is This Answer Correct ? | 91 Yes | 8 No |
Post New Answer View All Answers
What is the role of nitrogen in welding?
why boiler is closed system ?
Explain the difference between blower and fan?
Is radiography require in IBR piping of size 40 NB(1 1/2" inch)?
Explain working of a fourneyron turbine?
How i injecter setting qsk series cummins engine and i can using click type torqurench or dial gauge type
we use parallel flow heat exchanger to coo oil of 1000 EP viscosity,oftenly tubes may damage during cleaning etc what is proper way to clean cooler? How impurities decreased or vanished during working or in less teme job performed?
What is representative elementary volume?
What are considerations taken into account while creating a piston head?
any body hv a experience of L&T pget interview for mechanical thn send me question and experience to me as i hv interview on 8 th may so send me as soon as posssible on my mail id nilesh.spy2000@gmail.com
Give me an introduction about myself.iam a engineering student, i would like to know, wat is my qualification till my enginering is not yet completed?
what are the major duties of a mechanical engineer in a power plant.?
What is the principle of mechanical refrigeration ?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
Define emissivity.
