What are the loads considered when designing the Nut and
Bolts?
- 12 Answers
- 18005 Views
- I also Faced
- E-Mail Answers
Answer Posted / phani
bolt must be resist to highly tensile stress and nut must
be resist to highly compression
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
What do you mean by A.CC.?
What are the defects in exhaust valve?
Draw a crankshaft and show the parts?
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........
Which furnace burns low-ash fusion coal and retains most of the coal ash in the slag?
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
"In refrigeration, why during operations is running low pressure at the suction side?"
HOW MUCH HARDNESS OF CAST IRON?
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
Explain bearing
how to calculate transformer conservator size
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
How will you classify sliding contact?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
What are the different theories of failure under static load, explain ?
