Scenario: You created 2 access-lists for controlling telnet
about
a year ago, and bound one of them to Serial 0. You can't
remember which
access-list you
used. Which command lets you see all access-lists on Serial
0 for telnet?
A.) show access-list
B.) show ip int s0
C.) show access-list telnet
D.) show telnet access-list
E.) show access-list s0
F.) show int s0
- 2 Answers
- 4165 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Which way of communication bus topology use?
What are the two types of transmission technology use in ccna?
What is the difference between cross cable and straight cable?
What is difference between static and dynamic routing?
Which protocol supenetting is enable by default?
Explain how many ways to access router?
What is ‘round-trip time’?
how we update the IOS version with the help of TFTP?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is default packet size of ipv6?
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
Which type of routing you did in ccna?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
In port based access-list which command you give instead of ip?
What is EIGRP?
