Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashish
floting neutral means due to if voltage in all three phase
is not same due to asymmetrical load at output then voltage
drop through all phase are not same so neutral point is
shifted from center is prevent by mainten constant load at
all phase
| Is This Answer Correct ? | 20 Yes | 14 No |
Post New Answer View All Answers
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
why chock were used in old tubelights but are not newest tubelights?
star delta starter contorl circuit... drawing..
block diagram of 2 ups system connected in parallel mode?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Batteries. What is the difference between Lead and Nickel batteries ?
What are hrc fuses and where it is used?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
what is the difference between unarmoured & Flexible cable? How to identified?
What is difference between isolator and circuit breaker?
I want to replace the 3 KW DC motor with AC motor so what should be the rating of AC motor? Details Of DC motor to be changed with AC are - Kw - 3, Vf - 310, If - 0.15, Va - 400, Ia - 13, RPM - 2400
What are the factor to be consider for CT selection in 132kV substation?
In parallel operation time both NGR’s close or not close if both close what will happen
