Interested to Buy Any Domain ? << Click Here >> for more details...
what is a DLC?[just dont reply its a Dual loop
controller!] Plz do Explain the advantage of DLC over PLC?
- 3 Answers
- 9588 Views
- Essae, I also Faced
- E-Mail Answers
Answer Posted / mirza riaj
Powerline carrier systems (PLC) can be divided into two
segments, a powerline transmission segment and a downstream
powerline distribution network segment.
PLC systems applied to distribution networks have a group of
special technical obstacles that are not experienced in
transmission level PLC. Distribution line carrier (DLC)
signals must propagate through networks that are extremely
hard to model as the networks branch and mesh with each
other while experiencing highly variable levels of loading.
DLC signals must traverse a network that was designed to
carry power signals at 50/60 Hz and are optimized for this
task. Power transformers at PLC frequencies are modelled
primarily, at PLC frequencies, by their leakage reactance
and tend to block DLC signals. Capacitor banks used for
power factor correction present a low-impedance path to
ground and sink DLC signals unless they are trapped out with
reactors.
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
Write the force balance equation of m ideal mass element.
How to work E.L.C.B and how to connect in circuit.
PAC and simple Ac different
What is advantages of VSCF wind electrical system?
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
Explain the different regions in frequency response?
difference between power surge and switching transient
Explain what is clipper and clamper circuits?
how line turns ratio changes in 3 phase with change in connection
How many gap between finger contact in a.c.b. and v.cb.?
What aturn on methods of scr?
