Which of the following would be displayed by the command
'SHOW CDP
NEIGHBOR DETAIL'?
A.) The incoming/outgoing port.
B.) The hardware platform.
C.) One address per protocol.
D.) Amount of Flash Memory Available
E.) The routers hostname.
F.) The subnet mask, if IP is configured.
- 1 Answers
- 4167 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A B C E
CDP shows a lot of the same info that 'show version' does
locally, but
FLASH memory is not part of it. The 'detail' keyword is
optional, but
even when used, IP subnet mask information is not displayed
by CDP for
IP interfaces.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the steps of data encapsulation?
What is the command for change serial cost?
What type of transmission bus topology support?
Which type of transmission bus topology support?
When we do default route?
How many maximum paths you can give on latest ios in rip?
Mention what is the matric of eigrp protocol?
Explain types of communication in ipv4?
What is the default behavior of access-list?
what is the matric of EIGRP protocol?
Differentiate full-duplex from half-duplex.
What is ping used for?
What is the difference between static ip addressing and dynamic ip addressing?
How does PPTP encapsulate data?
How do areas benefit a link state inter network?
