Interested to Buy Any Domain ? << Click Here >> for more details...
What is the purpose and default value of the CDP timer command?
A.) 90 seconds; interval before an entry expires
B.) 60 seconds; interval between updates
C.) 60 seconds; interval before an entry expires
D.) 90 seconds; interval between updates
- 1 Answers
- 23766 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
The CDP timer controls when the update of CDP information
should be sent
to the neighbor router.
| Is This Answer Correct ? | 25 Yes | 5 No |
Post New Answer View All Answers
What is difference between flsm and vlsm?
What is 10base5 ethernet lans?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What are the different ways authentication mechanism in VPN?
What are the types of communication in ipv6 ?
In which protocol supenetting is enable by default?
What are the possible ways of data exchange in ccna?
What is difference between static and dynamic routing?
Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?
Explain the terms unicast, multicast, broadcast.
Explian what is a node?
Which command we give if router ios stucked?
in stead of 0.0.0.0 wild card mask what u can write after ip?
Which mode called privilege mode?
If line up, but protocol down which layer should be troubleshot?
