Interested to Buy Any Domain ? << Click Here >> for more details...
if the HR asked to me., you have got 92% in higher
secondary but got only 72% in engg whats the reason??what
should i have to say ..please help me..
- 8 Answers
- 13269 Views
- Honeywell, Wipro, I also Faced
- E-Mail Answers
Answer Posted / rajkumar r
The percentage of marks wil not speak to the true talent.
Tel them to test ur knowledge in the interview. Even 95%
scored student wont shine in his life bcoz of improper
communication skill and the way to explain the answer for
the questions asked in the interview. So dont look at the
marks.. Let them test ur talent. The way of reponse and
communication skill wil giv a better job..ALL THE BEST
| Is This Answer Correct ? | 25 Yes | 2 No |
Post New Answer View All Answers
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
Why to keep capacitor bank off while generator running.
How to calculate fault level of 11 KV system
State the frequency for rc phase shift oscillator?
What are the material used for inductance coil?
I need bhel electrical test pattern & paper
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
What is deference between MCB & MCCB & ISOLATOR
How RTCC panel is working and give single line diagram for RTCC with transformer?
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What are the advantages of vscf wind electrical system?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how solar power plant energy meter multiplication factor
EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?
