Answer Posted / gaurav naik
Helloooooooooooooooo
Question is
Do you have any P.L.C in your organization?
and its not
What is PlC and how it works
Why i am telling this is that,while answering Interview we
must be up to the point
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
What is Negative Potential Bias
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
How to checked frequency drive output voltages?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
what is is the potential diffrence between two phase ?
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
Where can I get Iidian straderd specifications for electrical items or works in web? please help me.
why three phase capacitor takes unbalanced current in capacitor bank?
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
how can motor both beasrings insulation resistance can be check?
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
