Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 2 rules used when configuring a Distance Vector
routing protocol?
A.) Physically connected network(s)
B.) Configure the classful address, no subnets
C.) Enable CDP so neighbors can be detected
D.) Configure all networks in Area0
- 1 Answers
- 4630 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A B
When configuring a Distance Vector routing protocol only
assign the
physically connected networks with the classful address only.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What type of transmission bus topology support?
What is the difference between tracert and traceroute?
What is quality of ipv6?
Which type of routing you did in ccna?
1350 Value in which type of access-list?
What is the checksum?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
How do you configure a Cisco router to route IPX?
Which ipsec rule is used for the olympia branch and what does it define?
What are the conversion steps of data encapsulation?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What is the function of the Application Layer in networking?
What are the types of resource sharing?
What does routing mean?
What is the difference between csma/ca?
