What is the difference between online ups and offline ups?
Answer Posted / martin
Online UPS is the one which gives output all the time from
battery whether there is power failure or power on. You
get backing from battery all the time.
Offline UPS supplies Mains to the output when power supply
is regular and charges batteries as well at the same time.
When power fails it switches those batteries to produce
output for power backup.
| Is This Answer Correct ? | 157 Yes | 29 No |
Post New Answer View All Answers
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What conditions are required for transformer to operate at low frequencies ?
1.4 What is meant by CT knee point voltage and how would you determine it
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
what is the difference between electrical choke and electronic choke?
What is the difference between circuit breaker and isolator
how generator avr give to the input?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
What is slope...? Explain slope 1 and slope 2...?