Interested to Buy Any Domain ? << Click Here >> for more details...
Which service uses telephone control messages and signals
between
the transfer points along the way to the called destination?
A. Signaling System 7 (SS7)
B. Time-division Multiplexing (TDM)
C. X.25
D. Frame relay
- 1 Answers
- 3807 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer:: A
Signaling System 7 (SS7) uses telephone control messages and
signals
between the transfer points along the way to the called
destination.
Time-division Multiplexing (TDM) has information from
multiple sources
and allocates bandwidth on a single media. Circuit switching
uses
signaling to determine the call route, which is a dedicated
path between
the sender and the receiver. Basic telephone service and
Integrated
Services Digital Network (ISDN) use TDM circuits. X.25 and
Frame Relay
services have information contained in packets or frames to
share
non-dedicated bandwidth. X.25 avoids delays for call setup.
Frame Relay
uses permanent virtual circuits (PVCs).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will be the prefix length of 224 in vlsm?
When we use loop back ip?
Explain what is the size of hello packets in eigrep protocol?
What are the types of communication in ipv6 ?
What are 10base2 ethernet lans?
Which defined peer ip address an local subnet belong to crete?
What is difference between flsm and vlsm?
What is default packet size of ipv6?
Is hsrp is cisco proprietary or introduced by ieee?
What is the key advantage of using a switches?
What is the size of IP address?
what is Bandwidth capping
What are the two types of transmission technology use in ccna?
If line down and protocol also down; in this case which layer move problem?
Which protocol called rapid protocol?
