Interested to Buy Any Domain ? << Click Here >> for more details...
what is full form of lv and mv? 2.while we connect
capacitor to generator what will cause for it?
- 4 Answers
- 32221 Views
- ABB, Wireman, I also Faced
- E-Mail Answers
Answer Posted / rajkumar r
LV-LOW VOLTAGE
MV-MEDIAM VOLTAGE
IF WE CONNECT CAPACITOR TO GENERATOR ADDITIONAL LOAD COME
UNDER DG MEAN TIME PF ALSO S IMPROVED
| Is This Answer Correct ? | 32 Yes | 4 No |
Post New Answer View All Answers
State the points to be considered for selecting a particular type wiring.
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
what is meant by skew width in machines?
what is vtg limit of earth and neutral at transformer side?
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
Why does inductive loads consume KVARs?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
what could be the RMS value and average value of a 4 phase sine wave?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
why do we lay up the core of a cable?
concept of busbar and load dispatching..?
what is method for testing CT
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
