To prevent Service Advertisements (SAPs) from flooding a
network, Cisco routers do not forward them. How are
services advertised to other networks?
A. Each router builds its own SAP table and forwards that
every 60 seconds.
B. Each router assigns a service number and broadcasts
that.
C. SAPs aren't necessary with Cisco routers.
D. Cisco routers filter out all SAPs.
- 1 Answers
- 7962 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer:: A
Cisco routers build SAP tables and forward the
table every 60 seconds. All SAPs can't be filtered even
with 4.x since NDS and time synchronization uses SAPs.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is DLCI?
In how many ways can data be transferred in ccna?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
If line up, but protocol down which layer should be troubleshot?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
What are the advantages of using switches?
Tell me how many fillers we can put in one ip of ipv6?
On which mode we give debug command?
What port does rip use?
Mention what is dhcp?
Define topology?
What is hold down time formula of ospf?
What are packets?
What is 10baset ethernet lans?
What is a vlan?
